PD Connex CX38-3 XLR to 6.3 mm Mono Audio Cable, 3 m

PD Connex CX38-3 XLR to 6.3 mm Mono Audio Cable

The PD Connex CX38-3 is a 3-metre mono audio cable with an XLR 3-pin male connector on one end and a 6.3 mm mono jack on the other. It connects microphones and audio devices with XLR outputs to equipment with 6.3 mm jack inputs, such as mixers, amplifiers, and portable audio interfaces.

• XLR 3-pin male to 6.3 mm mono jack ensures a secure, low-noise connection for professional audio signal transmission
• 3-metre length provides flexible positioning between stage equipment and mixing desks without signal degradation
• Mono configuration carries a single audio channel, ideal for unbalanced line-level signals from microphones and instruments
• Black outer jacket blends discreetly into stage and studio setups while offering durable protection

Das zeichnet PD Connex CX38-3 aus

The CX38-3 uses a standard XLR 3-pin connector on one side and a 6.3 mm mono jack on the other, making it a direct bridge between professional XLR-equipped microphones and gear with 6.3 mm input jacks. The 3-metre cable length is suited for stage, studio, and live-performance routing where the source and destination are within close range.

Ideal für...

Audio engineers and musicians who need a reliable mono link between XLR-output microphones and 6.3 mm jack inputs on mixers, amplifiers, or audio interfaces. Suitable for small venue sound reinforcement, podcast setups, and studio recording chains where cable length and connector compatibility are critical.

Anwendung von PD Connex CX38-3

1. Connect the XLR 3-pin male end to the microphone or device with an XLR output
2. Plug the 6.3 mm mono jack end into the corresponding input on the mixer, amplifier, or interface
3. Route the 3-metre cable along the stage or desk, securing it with cable ties if needed
4. Verify the mono signal path by checking for audio on the connected channel before going live