Kontakt Chemie SOLDABSORB Desoldering Wick 1,5 mm x 10 m

Kontakt Chemie SOLDABSORB – Professional Desoldering Wick for PCB Repair

The Kontakt Chemie SOLDABSORB is a precision desoldering wick designed for clean and efficient removal of solder joints on printed circuit boards. It enables reliable rework of electronic components without damaging sensitive pads or traces.

• 1.5 mm width provides the right balance of solder absorption speed and precision for most through-hole and surface-mount joints
• 10 m length offers ample working length for extended repair sessions without frequent replacement
• Flux-coated braid ensures smooth solder flow and clean joint removal in a single pass
• Compatible with all standard soldering irons and hot-air rework stations

Das zeichnet SOLDABSORB aus

The SOLDABSORB wick is engineered with a high-quality braided copper core that absorbs molten solder efficiently. The consistent 1.5 mm cross-section delivers predictable performance across a wide range of solder alloys and joint types, making it suitable for both hobbyist and professional electronics work.

Ideal für...

Electronics technicians, PCB repair specialists, and makers working on soldering rework tasks. The wick is particularly well-suited for repair stations, component replacement, and board-level troubleshooting where clean, residue-free joint removal is essential.

Anwendung von SOLDABSORB

1. Position the desoldering wick directly on the solder joint to be removed
2. Heat the joint and wick with a soldering iron until the solder melts and is absorbed into the braid
3. Slide the wick forward slightly and repeat if necessary for larger joints
4. Cut off the used section and continue with a fresh segment for the next joint