The EP shrink tube is a PVC heat-shrink sleeve designed for insulating and protecting wires, cables, and connections in RC and model-building applications.
Transparent finish allows visual inspection of the covered connection without removing the sleeve
2 m length provides ample material for multiple cable runs or repairs in a single workshop session
45.8 mm diameter accommodates a wide range of wire bundles and connector housings
PVC material delivers reliable electrical insulation and mechanical protection against abrasion and moisture
What makes the EP Shrink Tube stand out
Unlike opaque heat-shrink alternatives, the transparent design lets users verify wire polarity, connector orientation, and solder joint quality after shrinking — saving time during assembly and troubleshooting in the RC workshop.
Ideal for
RC hobbyists and model builders who need a clean, inspectable wire finish on servo leads, motor connections, and receiver wiring. The generous 2 m length suits both small repairs and full cable harness assemblies.
Application of EP Shrink Tube
Slide the tube over the wire or connector before soldering or crimping
Position the sleeve over the area to be insulated
Apply heat evenly with a heat gun until the tube contracts tightly around the cable
Allow to cool and inspect the sealed connection through the transparent wall
EP is a specialist brand for heat-shrink tubing and cable protection products, widely used in RC workshops and model-building environments. The brand focuses on practical, no-frills solutions for wire insulation and connector protection.
The EP shrink tube is used to insulate, protect, and organize wires and cables in RC models, servo connections, motor leads, and receiver wiring.
The tube has a diameter of 45.8 mm and a length of 2 m, providing enough material for multiple cable runs or repairs.
The tube is made of PVC (polyvinyl chloride), which provides electrical insulation, mechanical protection, and resistance to abrasion and moisture.
Yes, the tube has a transparent finish, allowing users to inspect the covered wire or connection without removing the sleeve.
Slide the tube over the wire before soldering, position it over the area to be insulated, apply heat evenly with a heat gun until it contracts, and allow it to cool for a secure seal.
Subscribe to the newsletter
New arrivals, promotions and exclusive offers — straight to your inbox.
Please complete your information below to login.
Sign In
Create New Account