Delock Conversion IOT Cable 10 cm, 4 Pin to Jumper

Delock Conversion IOT Cable 10 cm – 4 Pin Grove to Jumper Connector

The Delock Conversion IOT Cable is a 10 cm cable with a 4-pin Grove connector on one side and a 4× jumper connector on the other. It enables direct signal routing between Grove-based sensor/actuator modules and standard 1-pin jumper headers on development boards.

• 4-pin Grove connector provides a secure, polarised connection for Grove modules
• 4× jumper connector on the opposite end fits standard 1-pin header sockets on microcontroller and development boards
• 10 cm cable length keeps the connection compact and reduces clutter on the bench
• Delock quality construction ensures reliable contact and durable strain relief

What sets the Delock Conversion IOT Cable apart

Unlike generic jumper wires, this cable uses the standardised Grove 4-pin interface on one side, so Grove modules plug in directly without adapters. The 10 cm length is purpose-built for tight breadboard and development board layouts where longer cables would create unnecessary slack.

Ideal for...

Maker and prototype builders working with Grove-compatible sensors and actuators who need a clean connection to a development board's 1-pin headers. Also suited for educational labs and workshop setups where multiple Grove modules are mounted close together on a single board.

Application of the Delock Conversion IOT Cable

1. Connect a Grove module to the 4-pin side of the cable
2. Route the 10 cm cable to the target development board
3. Plug the 4× jumper side into the corresponding 1-pin header sockets
4. Verify signal integrity by powering the module and reading sensor values